Dome 6.15 K2 upper support for flat roof (15 degrees)

Peak is the part that raises the upper edge of the panel on a flat roof. In the 15-degree version it is taller and more robust than the 10-degree one, because a more tilted panel is gripped harder by the wind. It is fastened either by clipping into the base plate, or with a screw directly on the rail, both solutions being fast.

The part weighs 0.411 kg, more than the 10-degree version, precisely because the profile is taller and takes higher wind forces; the extra weight is part of the solution, it is not a disadvantage. Installation is done by clipping into the pre-mounted base plate or by fixing directly on the BasicRail rail with a hexagon socket screw and an MK2 sliding nut. It works in a pair with the front element Dome 6.15 SD, on a BasicRail rail, and the modules are fastened with DomeClamp clamps. The factory packaging is 20 pcs/box and 720 pcs/pallet.

Dome 6.15 Peak, K2 article code 2004174, GTIN 4251786206278, EN AW-6063 T66 aluminium, 0.411 kg/pc, upper element for raising the module to 15 degrees. Compatible with the K2 Dome 6 and K2 BasicRail systems, usable on flat roofs and on slightly pitched roofs; installation by clipping into the base plate or fixing on BasicRail with a screw and MK2 sliding nut. The Dome 6 system is covered by the German technical approval abZ no. Z-14.4-916, and the ballast sizing is carried out in the K2 Base application.

Who it suits

Suitable for industrial halls and buildings with a flat roof in areas with frequent snowfall, where the greater tilt helps the snow to slide off the modules.

Terms explained

• Peak element: The rear support, the tallest one, which gives the angle at which the panel sits on the flat roof.
• Wind forces (uplift): The wind passing over the panel tends to pull it upwards, like a wing; that is why the supports and the ballast are sized according to the wind zone.
• K2 Base: The manufacturer's calculation program, which determines how many parts and how much ballast are needed for the respective roof.

Technical specifications

Recommended applications

• Raising the panels to 15 degrees on flat roofs
• Areas with frequent snowfall, where the greater tilt helps the snow slide off
• Commercial installations on industrial halls with a flat roof
• S-Dome 6.15 configurations with a wind deflector on the rear side

Warranty

12 years K2 Systems product warranty, extendable to 20 years through sizing in K2 Base and documentation in K2 DocuApp

Technical details

Specifications confirmed from the manufacturer's datasheet

Dome 6.15 Peak is the module raising component for the 15-degree version of the K2 Dome 6 system intended for flat roofs. The element clips into the pre-mounted base plate or is fixed directly on the BasicRail rail with a hexagon socket screw and the MK2 sliding nut, which allows fast installation on site. K2 article code 2004174, GTIN 4251786206278.

The material is EN AW-6063 T66 aluminium, and the unit weight is 0.411 kg - higher than in the 10-degree version, because the profile is taller and takes higher wind forces. The factory packaging is 20 pcs/box and 720 pcs/pallet.

It is used together with the front element Dome 6.15 SD, with the BasicRail rail and with the DomeClamp clamps. It is compatible with the K2 Dome 6 and K2 BasicRail systems and can be used on flat roofs and on slightly pitched roofs. The Dome 6 system is covered by the German technical approval abZ no. Z-14.4-916, and the ballast sizing is done in the K2 Base application.